MS-05L ZAKU I SNIPER TYPE [YONEM KIRKS] - Part 1

Zeon has always been my favourite party. Regardless of the era, the evil schemes have always been the highlight of the entire show. Without it, the series would be dead by now. 

Not to elaborate much, this is Zaku Sniper I. 

I just love the booklet.

It should be fine for a HG model with that number of runners.

Would you look at that. All about circles. 

Yes, I held the PC/PE upside down. Just bear with it or tilt your heads a bit.

That puts and end towards the introduction of the bits and pieces inside the box. Let's proceed with the torso, a big part with not much of a work to do. But that doesn't mean lacking off is an option. A modeling cement (Tamiya's should do the trick; if you have any other clear cements, that should do the trick too.) is needed. You'll see the use of it once you bought this model. 

See those rough surfaces? Sanding them are very much appreciated.

The torso is done. Now, moving on to the backpack.

To be continued in part 2 of this post.